Omaerang metal processing industry integral energy-saving program: There are many processes in the metal processing industry, and Omerang has designed a complete set of energy-saving solutions for hot water cleaning, metal parts cooling, and metal parts drying!
Jiangsu Oumerang Special Omalang 85 degree high temperature heat pump unit can be used for hot water required for most metal parts cleaning. Compared with the conventional electric heating method, the energy saving is nearly 70%, and the whole system is combined with the metal parts production line to automatically adjust the heating time and heating temperature according to the production needs. Fully automatic operation, no need for special supervision, saving labor costs.
For the cooling of metal castings, O'Myron is equipped with two heat pump units depending on the cooling method. (1) Air cooling method: that is, air cooling on the periphery of the metal type to strengthen convection heat dissipation. According to this cooling method, Omalang is equipped with a large cold air heat pump unit, which can produce cold air at about 5°C for air cooling cooling. The same is fully automatic operation, equipped with PLC remote control, support computer, mobile phone remote control!
(2) Water-cooled cooling: the water jacket is directly made on the back or part of the metal type, and the water is passed into the water jacket for cooling, which is mainly used to pour steel or other alloy castings, and the casting requires strong cooling of the part. For this cooling method, Omerang is equipped with a water-cooled scroll chiller, which can produce low-temperature cold water of about 5-10 degrees. Fully automatic operation and remote control are also supported!
After cleaning, there is a large amount of moisture left on the surface of the metal parts, which needs to be dried off as soon as possible. Omaerang is equipped with a fully automatic drying machine according to the drying of metal parts, which can be combined with the production line to operate! It can produce hot air at about 20-85 °C, and run automatically according to the production needs of the production line. At the same time, this system also has a dehumidification function to avoid damage to metal parts caused by high temperature and high humidity gas.
Similarly, this automated drying system is equipped with a waste heat recovery device. The waste gas generated by the drying line can be recovered and reused for the heating of the fresh air of the drying line, killing two birds with one stone. Further save energy costs for enterprises!