Hello everyone, I'm Long'er, I accidentally got a nut stuck on my finger, I can't take it off, what should I do?
So today I will teach you a trick, you only need to wrap it around the nut with a thread, and you only need to pull it gently, and the nut will fall off automatically.
This method is very simple to operate, and today I will share this method with you.
This nut, we can see that it is stuck very tightly in the hand, there is really no gap at all, and no matter how I pull it, how I pull it down, he is still as steady as Tarzan, and he does not move in the original position, even if I twist it like a knob, it does not move at all.
Many friends encounter this kind of situation, they are very anxious, in a hurry, many friends will choose to pull out and drag with their hands, and if they can't take it off, they will think of using dish soap, soap or soap at home.
But we found that even though we applied a lot of soap and soap, it still didn't work, because soap and soap only lubricated, and it didn't change the size of our fingers or the size of the nut ring.
Therefore, in this case, that series of old methods is completely undesirable and has no effect, so let's leave it alone at this time.
Find a broom in the house or a brush for brushing the bed and sofa, pluck a bristle from the top, and try to choose a longer one when choosing the bristles.
Because our nut is relatively large, so say, the length of the bristles should also be long enough, after pulling it out, we fold it in half to see the length, the length can be greater than the width of the nut, you can put it aside for later use.
At this time, we take out the hand that is stuck in the nut, and then prepare this kind of embroidery needle in the home, gently poke the embroidery needle in, and when poking, everyone's strength must be on the side of the nut, if you are going to the direction of the hand to top, then the hand will be pierced.
After we use the embroidery needle to jack it up, then there will be a little gap between the hand and our nut at this time, although this gap is not big, but it is always a little looser than just now.
Because after our embroidery needle is poked in, the embroidery needle will produce a concave situation on the finger, then there will be a little gap in this concave surface, at this time, we can use this gap to gently push forward the bristles that have just been removed from the brush.
Then after a while, the bristles were pushed out by us, seeing the bristles that were not pushed out, the double-ended place just happened to be passed out smoothly from the nut, at this time we can carefully pull the embroidery needle that was poked into it slowly outward, until it is completely pulled out, and there is no need to pull it out, at this time we will prepare a rope.
Then we can start with a thicker rope, because the thicker the rope, it is stronger and not easy to break, and then thread the rope into the bristles, and the thread I use here is the thread on the rice bag.
Let's try it now, gently pull the bristles in the opposite direction of the thread, the action should be slow when pulling, and the force should be slightly larger, otherwise if the card is very dead, it is difficult to pull it out, if the force is too strong, it is easy to scratch our fingers.
If your nut is tighter than my nut stuck in your hand, then it is recommended that you replace the thread with the thread that you usually sew clothes, the thinner the better, so that it will be easier to wear it in.
After making sure that the thread is passed through the nut, we can remove the bristles.
At this time, gently pull our thread outward with our hands, pull the double thread into such a single thread, adjust the length of the thread, and ensure that the thread on the tip of the finger is longer than the thread in our palm, and then the hand tightly presses the thread at the palm.
In the process of winding, the thread will cause a squeeze and pressure on the skin on our hands, so visually speaking, the fingers will be a little smaller, and we will wrap the thread all the way to the top of the fingernails.
After all is wound like this, we now wind it out from the end of the wire at the end of the nut from the opposite direction, in the process of winding, we also have to ensure that the wire will have a squeeze on our nut, and the nut will be lifted up with such a force, while pulling and rotating, so that the nut can be loosened and the nut can be better removed.
Many friends think it's incredible, why is the nut stuck in the hand?
In fact, it is very simple, especially the children in the family, usually when watching adults take screws and nuts to repair things there, they will feel fun, and then they will also play with their hands, play and feel that they are set on their hands, and it is quite fun, but as a result, they found that they can't take off the set on their fingers for half a day, and they pull hard, and the children are still crying, I believe many friends have encountered this kind of situation.
Therefore, today I will share with you a little trick to remove the nut, in the process of we keep going up, the nut is very easy except for the joints of our fingers, as long as the joints are removed, then the nut will easily fall, look at the hand did not leave any scratches, only some nut left indentations.
The tooth marks that are entwined with our thread show that this method is really great!
Today, I mainly share with you a small way to take off the nut if the child or other person in the family accidentally puts the nut on the hand and can't take it off.
In fact, today I will share with you this method is not only suitable for taking nuts, like our ring-shaped thing accidentally stuck on the hand and can't take it off, you can also use this method to take it off, for example, our rings in life are similar to this principle.
Therefore, in the future, our female friends or some old people will wear the ring on their hands for a long time, and then they will be blessed again, so it is particularly easy to cause it to be unable to take it off.
Then you can try the method of taking the nut that I shared with you today, you can take it off smoothly in just a few minutes, and it won't hurt your hands, like my video, remember to like and follow and collect.
So that's all for this issue of video sharing, let's see you in the next video, bye-bye. #头条创作挑战赛#