Analysis of the reasons for the low powder output of Chinese medicine ultra-fine grinder

　　The future will be an era of intelligence, and the manufacture of Chinese medicine ultra-fine crushers will also use smarter equipment to achieve innovation and improve the safety performance and work efficiency of Chinese medicine crushing. The use of intelligent operating system can greatly improve the ability to solve problems in use to a certain extent, so that the smashing of traditional Chinese medicine has no worries, and also solves major problems for enterprises.

　　The crushing technology of Chinese medicine ultra-fine crusher mainly refers to the cell-level wall breaking micro-crushing technology, usually, it needs to be crushed to more than 200 mesh. The main medical components of Traditional Chinese medicine are usually distributed in cells and intercellular spaces, and cells are mainly used. After the cell wall ruptures, the active ingredients in the cells are exposed, the release rate and amount of the drug will be greatly increased, the efficacy of the drug will be greatly improved, and the onset of action will be very fast.

　　The amount of powder produced by the Chinese medicine ultra-fine grinder directly represents its economic benefits, and if the amount of powder becomes lower during the processing process, it will directly lead to the rise in processing costs. What are the reasons for this when this happens?

　　1, equipment speed: the equipment mainly through the frequency conversion controller to adjust the speed of the equipment. If the speed is high, fine powder will be produced, and the output value will be slightly lower, if the speed is low, the material will be coarser and the output value will be larger.

　　2, the amount of equipment feed: when the amount of feed is small, the equipment of the ultra-micro mill will not be saturated, and the inside of the mill will not be saturated, and the particle size of the products that are played out will not be as good as the particle size of the full load work, and the output value will not be high at full load.

　　3, the viscosity and humidity of the material: some materials become viscous or overly sticky at high temperatures, in the process of milling, this type of material will not only simply stick to the inside or outside of the equipment, causing blockage of the outlet, resulting in a reduction in the amount of sand, and even, when serious, it will cause certain damage to the grinding equipment.

　　4, the hardness and fineness of raw materials: the particle size of the feed during the crushing process is 3-5cm, lower or higher than this specification will directly affect the yield value.