Today we understand the car burning oil, in fact, there are many reasons for the car to burn oil, common valve oil seal oil leakage, crankshaft oil seal oil leakage, turbine oil seal oil leakage, exhaust valve damage, etc., but the piston oil ring stuck is also a major cause of burning oil.
The existence of the oil ring is to scrape off the excess oil adhered to the cylinder wall, preventing the oil from entering the cylinder, leaving only a thin oil film for the lubrication of piston movement. Once the oil ring is seriously worn or carbon deposits are generated, the oil ring loses its previous elasticity, then the excess oil on the cylinder wall cannot be scraped off, and a large amount of oil will be directly burned from the gap between the piston and the cylinder wall into the combustion chamber during each piston movement stroke, which directly leads to a reduction in the amount of oil.
So how is the carbon deposit on the oil ring formed? Carbon deposits in this area are mainly formed by motor oil. The main function of the oil ring is to scrape the oil cloth oil, so it is always covered with oil. Under the action of the piston at high temperatures, these oils will slowly coke, solidify, and eventually form carbon deposits. This is the formation mechanism of carbon deposits in the oil ring area.
These carbon deposits are deposited on the oil ring or piston back oil hole, which will shrink or even block the oil return hole, reduce the oil scraping effect of the oil ring, and the oil scraped off cannot be smoothly returned to the oil pan; the most serious consequence is too much carbon deposition, the entire oil ring is deposited with carbon deposits, the oil ring is "hugged", there is no elasticity, the oil scraping effect is greatly reduced, and the oil consumption rises significantly, which is the so-called "burning oil".
So how to remove the carbon deposits in this location? Let's talk about it. If it is a slight burning oil, then it can be completely cleaned with a carbon deposit cleaner. No problem, but if the carbon deposit is very serious, then it is impossible not to burn the oil in the short term, because the carbon deposit in this part is very hard, it can be said that it is harder than the stone. The quickest way to do this is to replace the oil rings, but this will be listed as an engine "overhaul". If you really don't want to, you can also clean up through the "immersion" type, but it takes a long time, two or three days. To put it bluntly, it is to release the oil ring, restore the elasticity, and restore the original oil scraping effect of the oil ring.
Therefore, changqing carbon deposition is very necessary, especially German cars, American cars, are pursuing high power, high torque, carbon deposition generation will be faster. So we recommend cleaning up 10,000 kilometers at a time, so that the car is always in a "young" state.
Our recommended products have invention patent certificates, and we ourselves have been tested many times, safe and reliable, and in the past 4 years, we have also been recognized by many riders. The way to use is also very simple, to the gas station, first add the product to the tank, before filling the tank with oil.